Setup
Loader runs, the menu opens, but it is all greyed out and I get no ESP or aimbot. The overlay itself shows. Status is green.
Windows says Core Isolation is on. What actually causes the menu to be greyed out and how do I fix it?
7 Replies
- factory_gremlin
Grey menu means HVCI / Core Isolation reads on in Windows but off in BIOS. Enable it in firmware and reboot.
- eftcheat_staff Staff ✓ Solution
A greyed menu with a working overlay is almost always HVCI or Secure Boot off in BIOS. Turn on HVCI, TPM and Secure Boot, reboot, then relaunch in the order on Setup. Cloud DMA needs those on.
- quiet_pmc OP
Windows definitely says Core Isolation is on though.
- factory_gremlin
That is the exact trap. Windows says on, firmware is off. Check BIOS directly.
- gpu_hoarder
Also make sure Secure Boot is actually enabled, not just supported — different line in most BIOS.
- quiet_pmc OP
Secure Boot was off in BIOS. Enabled it, rebooted, every toggle went live. Thank you.
- timmy_nomore
Bookmark this for the next new buyer — it is the number one first-launch issue.
This thread is closed.
Replies were disabled after the discussion wrapped up. For account or license
questions, contact Support.